I have a file that I have been converting for sometime now with no problems and now I receive the message "BLOCK TOO LARGE FOR TEXT REGISTER, TRY CLIPBOARD" .
There are 12 files converted using the same code before this file and they all convert with no problem.
This is my code. EBCDIC-4 is already loaded in Reg 100 by this line used on the first file "Call_File(100,"C:\Vedit\EBCDIC-4")".
FILE_COPY("C:\XXXX-Lay-Files\F12.LAY","C:\Vedit\EBCDIC.LAY",OK) // Copy my layout file to EBCDIC.LAY.
FILE_OPEN("C:\Quarter-End\MEMF12") // Open the EBCDIC file.
CALL(100) // Call EBCDIC-4 from Reg 100 and run
FILE_CLOSE() // Close the file.
The file is only a small file containg 14,524 lines, 159764 Chars.
My Vedit is Ver 6.22.1E and system is Windows 7 Ultimate 64bit with 4gig memory running Intel i5 CPU.
I'm sure I have had this message before and posted on the old board but that seems to be closed now.
Any suggestion welcome.